Duo therm manual thermostat

Duo-Therm Thermostat Adjustment. While this is a nice convenience, some Dometic thermostats cannot be adjusted, even if you use the screws placed on the device by the company. One RV owner had this trouble and tried to find a way to adjust the thermostat but to no avail. DIAGNOSTIC SERVICE MANUAL. Duo-Thermfi. Comfort Control Center Systems SYMPTOM CAUSE REFER TO STEP. This program will address the most common system problems associated with the Duo-Therm Comfort Control Center supplied by The Dometic Corporation.  · If you experience a Dometic Duo-Therm 4 or 5 button Climate Control thermostat (as pictured) that fails to operate a furnace or air conditioner, thermostat owner’s manual. This thermostat is capable of operating several appliances (heat pumps, air conditioners, furnaces). The thermostat may have 2 or more “zones”Missing: cool cat.

on Duo Therm Rv Thermostat Wiring Diagram. The Dometic Single Zone Liquid Crystal Display (SZLCD) PN's XXX are Route a dedicated 12VDC supply wire (AWG) from the RV's converter (filtered side). Route two 18 gauge thermostat wires from the furnace to the roof opening of the unit that will See chart on page 3 of your installation manual. Description. Dometic™ (Duo-Therm) Thermostat 6-Wire Analog Control Heat/Cool. This thermostat gives you control of your A/C unit and furnace. This is a direct replacement for the Duo-Therm Thermostat. It must be used with the Control Relay (obsolete product). The part number for your thermostat should be located on the back of the T-Stat or on the control board of the T-Stat. Duo-Therm Thermostat Adjustment While this is a nice convenience, some Dometic thermostats cannot be adjusted, even if you use the screws placed on the device by the company. One RV owner had this trouble and tried to find a way to adjust the thermostat but to no avail.

or want more information about your system, refer to the Operating. Instructions manual. PDV. K. ; WWWXXXXXXX. Duo-THERM by Dometic. My Dometic AC had the manual nob controls on the ceiling. It was not wired with an existing thermostat or with a 12v supply already attached. IMPORTANT: Failure to follow these lighting instructions exactly may result in damage to the unit. 1. Set thermostat to highest setting. Remove front panel. 2.